• U.S.A. Pre-Fabricated Steel Buildings
logo

Wind Bracing

Wind Bracing

Steel buildings require wind bracing, there is no way around this fact. The size and weight of rigid frames standing upright, makes them act as very large domino’s. If the first one falls, it will take the rest along with it. The amount of bracing required for a steel building relies on many different things ranging from the size of the building itself, to external loads or forces applied. There are many different forms of wind bracing, which one is best is determined more by the layout of the building and the customer’s needs. The one obstacle is having an open bay for the bracing or adjusting sizes or layout for bracing to work.

End wall bracing

First; the simplest form of bracing is cross bracing. This requires cable or rod between two columns. This bracing normally requires an open bay.

Second; the next choice is called cable or rod to frame. This is where cross bracing is used in the roof area, connecting the top of end wall columns to the next rigid frame. This opens the availability of all bays for openings.

Third; the final choice is to use a half loaded rigid frame. The rigid frame requires no bracing from one column to the other, when used on an end wall and can also remove the need for internal columns.

Sidewall bracing

The sidewalls create a different problem. Here there are basically 4 types of wall bracing available. The number of openings on a sidewall determines bracing.

First; Cross bracing. This is the simplest and less expensive. This does require an opening bay with no framed openings. This could be cable or rod depending on seismic load and wind speed.

Second; Torsional frame bracing. This can only be used on a low building, nothing higher than 14 feet and only on one side, the opposite side must be completely braced. The roof slope should not be greater than 1:12 pitch.

Third; Portal frame. To use this type of framing you must have ample room on both sides and top of your framed opening, as the portal will take an additional room. All of the above choices do not affect the foundation design.

Fourth; Wind Column. This is a beam that mounts to the web of a frames column and bolts directly to the foundation at the base. Because this connection creates a moment type of force, the foundation requirements (concrete depth) can be very large. This remains our last choice to use for bracing. This method should also not be used on tall buildings or in high seismic areas. The amount of bracing required in a wall can vary, depending on building size and Engineer requirements. Normally bracing on sidewalls should not allow more than 5none braced bays before additional bracing is required. However, in the case of large buildings, additional bracing can lower the price by relieving additional stress on the frames.